![]() - Reactivating the standby timer in User Settings mode U1, U2, or U3 would cause the shutter speed to change if the stored value was slower than 30 s.- The camera would sometimes fail to focus on the subject in the focus area in pictures taken immediately after the battery was inserted.- Memory recall has been altered so that regardless of the focus mode selected, the focus position chosen via autofocus does not change if the shutter-release button is pressed halfway while memory recall is in effect.- The camera focuses more readily on the subject in the center of the frame if it fails to detect the face or eyes of a portrait subject when Auto-area AF is selected for AF-area mode.As of April 20, 2022, these features are available only with the following lenses:.- Save focus position and Recall focus position 2 to the roles that can be assigned using Custom Setting f2 ( Custom controls) in the CUSTOM SETTING MENU.- Switch focus/control ring roles 1 to the CUSTOM SETTING MENU in position f10, and.- Focus ring rotation range 1 to the CUSTOM SETTING MENU in position f9,.- support for NIKKOR Z 800mm f/6.3 VR S lenses,.Fixed an issue occurring when the camera was powered via USB that resulted in the supply of power ending after 15 hours of continuous use.Ĭhanges from “C” Firmware Version 1.31 to 1.40.Made improvements to focus-ring response when is selected for.Added support for MC-N10 remote grips.Added support for the iOS edition of NX MobileAir, starting with NX MobileAir version 1.0.4.Ĭhanges from Previous Versions Changes from “C” Firmware Version 1.40 to 1.50 - Focus could still be adjusted using the focus ring when was selected for in the if an option other than was chosen for in the.- In some cases, the OK button could not be used to interrupt the interval-timer or focus shift photography when the viewfinder was used.- A drop in brightness sometimes occurred in part of photographs taken using a flash.The monitor mode has been replaced by and.- Added and options for Custom Setting d9 >.Made the following additions to the :.Read the information below before proceeding.Ĭhanges from “C” Firmware Version 1.50 to 1.60.This update includes all changes made in previous updates.You will not need to download or install this update if the firmware listed above is already installed. ![]() Before proceeding, select in the camera and check the camera firmware version. ![]() This service supplies software that can be used to update the Z 7II camera “C” firmware to version 1.60.Be sure you understand the terms of the agreement before beginning download. By selecting “Accept” and clicking “Download”, you are held to have accepted the terms and conditions of the agreement. This software update program is for the customer-owned product listed above (the “affected product”), and is provided only on acceptance of the agreement listed below.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |